Harry Potter Deatly Hallows Lamp

thingiverse

As a birthday gift i created this lamp from scratch. To be fair, this is highly inspired by a post i saw on the internet, but i wanted a better and 3d printable base. U need multiple non-printed parts: 1. Lightbulb E27 2. Lampshade out of jute (20cm top and around 25cm in lower diameter) 3. Lightbulb electrical fitting for E27 4. electrical wire of your choice (i picked textile sleeved) 5. on/of switch and plug. to make the instalation easier i fitted 2 copper threaded inserts (M3) into the top and screw in the lampshade and drilled two holes in the base of the shade. To connect the printed parts, you can use a 6mm tube for the alignment and then glue. i used a 6mm bronze bar i got lying around. I also used a bronze wire to hold the deatly hallow shadow form on a distance, but just glue it inside the shade ... this isn't so elegant but will to the trick while hiding the shadowline on the bottom. for the german users: This is the shop where i got most of the parts https://www.creative-cables.de/schalter-und-dimmer/20375-einpoliger-zwischenschalter-creative-switch-weiss.html# The shade from here: https://www.ebay.de/itm/143293072962?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649