Hard Drive to DVD Drive - 3.5 inch to 5.25 inch. V2

thingiverse

Thanks for the original model on this Anwar! I reduced the amount of plastic used and minimized the need for supports. It's nowhere near as pretty, but it prints faster. Also made two of the hard drive screw holes more accessible. Differences in V2 (Printed in Red): I found the outer set of screw holes too large, so I shrunk them down to accommodate a standard computer screw thread. A slight increase in one set of recessed holes for screws that go into the hard drive. Made the sled of the bracket shorter. Added another hole to the sled, decreasing plastic and print time slightly. Print Settings: Printer Brand: Robo 3D Printer: R1 ABS + PLA Model Rafts: No Supports: No Resolution: .2 MM, Matter Control Medium Settings Infill: 12% Notes: Printed in PLA.