Happymodel EP2 ExpressLRS folding TPU holder

thingiverse

These folding TPU holders for Happymodel's EP2 ExpressLRS receiver have been designed to be reusable and easily printable. There are 5 different versions: Plain (use tape or something to hold it down) 16x16mm mount 20x20mm mount 25x25mm mount 30x30mm mount Print in TPU at 0.2mm layer height, 3 perimeters, 100% infill, no support. I also included the original model I made of the EP2 which I used to make the folding holders, in case anyone wants to use it to model their own holder. Installing: VERY IMPORTANT: The receiver goes in the top part first, then folds down onto the bottom part. See 2nd photo. After printing, without the receiver in, carefully fold the 'hat' over into the hole in the top of the holder, then fold & close the holder and open it back up to understand how it works and the force needed to close & open it. Then carefully place the receiver in the top half of the holder with the protection 'hat' for the ceramic receiver, then fold it down onto the bottom half. Best to put the RX in the holder before installing it in your craft. When opening it back up to get to the RX, remember it stays in the top half, then hold the 'hat' to pull the receiver out of it. Direct downloads from my website: http://www.haku.co.uk/3D/Happymodel_EP2_plain_holder.stl http://www.haku.co.uk/3D/Happymodel_EP2_16x16_holder.stl http://www.haku.co.uk/3D/Happymodel_EP2_20x20_holder.stl http://www.haku.co.uk/3D/Happymodel_EP2_25x25_holder.stl http://www.haku.co.uk/3D/Happymodel_EP2_30x30_holder.stl http://www.haku.co.uk/3D/Happymodel_EP2.stl You can sell prints of this, but don't overcharge, and link back here. Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit. Most FPV people may know me as licensetodrive on YouTube https://www.youtube.com/user/licensetodrive