Happ/IL/Sanwa Joystick Centering Spacer
thingiverse
Update 2024/07/20: Added Sanwa joystick sizing (smaller inner diameter)Update 2024/07/11: Added separate 28mm and 29mm spacer STLs since a joystick hole on one of my cabinets was slightly larger than the original one I made this spacer for.This is a spacer used to easily center a Happ or IL joystick with a 10mm shaft in a 29mm hole. I used this by putting it on the joystick shaft, then putting some painter's tape on the top of the control panel at edges of the hole to hold the spacer in the hole while I flipped the control panel over to screw the base of the joystick in place. I then pulled the joystick shaft out, removed the spacer, and installed the joystick into the base normally.
With this file you will be able to print Happ/IL/Sanwa Joystick Centering Spacer with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Happ/IL/Sanwa Joystick Centering Spacer.