Hanging Speaker Bracket for Klipsch R52c Center Channel Speaker

prusaprinters

I needed to find a way to suspend my Klipsch R52C center channel speaker from my fireplace mantle. The speaker was too tall to simply set on top.. so this was my quick solution. Built in Autodesk Fusion360. The original CAD file is included if you need to change the dimensions. For weight balance, I printed 4x of these pieces. 2 for the front and 2 for the back. Print in one piece (if you have a large enough bed); or two pieces that are interconnected with a dovetail splice. Depending on your tolerances, it may take some force to connect the pieces. It should be a nice tight fit.Use #6 or #8 wood screws to fasten. Once measured out and screwed in, simply slide the speaker into the four brackets. You may use rubber feet in the front or back to prevent it from sliding, but the weight should hold it in place..This system was printed in Black Hatchbox PLA, but could also work with PETG.Settings:Layer Height: 0.2; Walls/Perimeters: 4; Top/Bottom Layers: 3; Infill: Grid @ 15%; Print on sides for extra strength; Supports - none needed.