Hanging Bicycle Wall Mount

pinshape

I designed a bike mount that would minimize space usage and reduce the amount of filament required to print or require any assembly. It went through multiple design iterations before reaching its final form. The bicycle in the photos weighs approximately 16 kg. Printed on a Wanhao Duplicator i3, using the following settings: Plastic: PLA Infill: 100% (I suspect it will work at lower percentages, but I wanted to be cautious.) Layer height: 3 mm Bed temperature: 65°C Print temperature: 215°C The screw holes print at about 5 mm in diameter, so you'll need some screws that fit into them, along with some washers to prevent damaging the base. A drill is required to attach the mount to a wall. Note: You will likely need to rotate the model about 30-45 degrees for it to fit on the print bed. It's just slightly too large otherwise. I hope this design proves useful! Special thanks go to Hennie for allowing me to use his 3D printer, and Sebastian for lending me bicycles to test it with!