Handy sleeve adapter for stock sleeve

thingiverse

Sleeve adapter for The Handy, designed to hold the stock sleeve down lower, closer to the bottom of The Handy. UPDATED HINGED VERSION 5.13.2021: Hinged one-piece version. Newest version prints as one piece and is hinged for easier handling. The 84mm version is the standard version, and it holds the sleeve flush with the base of the Handy. I prefer the longer 94mm version because it holds the sleeve a little bit lower. [UPDATE 10.3.2021: I've added a 104mm extra long version.] ORIGINAL VERSION: The original version is a two-piece version. The stl is a half cylinder. Print it twice (two identical pieces, not mirrored) to create both halves of the cylinder and then the pieces should snap together, depending on your printer tolerances. It also comes in both the 84mm and 94mm versions. PRINT SETTINGS: I printed the hinged version with tree supports with overhang angle set to 80, so only the hinges are supported (all of the nubs on the inside and out are half spheres, so they should print fine without supports). I used PLA with 4-shell walls and 20% infill. The non-hinged version can be printed without supports. With either the hinged or non-hinged version, it is designed to be put over the sleeve after you have already put the sleeve on and squeezed all the air out of the sleeve. Then strap the whole assembly into the Handy.