Hands Free - Remote Foot Press Door Opener

prusaprinters

<p>Unlike available hands free openers, this design offers true hands free operating experience.<br/> Remote foot press pulls the door handle with tied rope (cord). Its required to screw press to bottom corner of your doors.</p> <ul> <li>Interlocked articulating print in one go</li> <li>Print-ready vertical orientation for press and rope holder</li> <li>M3, M4, M5 versions available for rope holder</li> <li>You can use press with most available hands free (elbow) opening handle designs<br/> -Choose your best knot tying method (you might even avoid use of my knot holder at all)</li> </ul> <p>Demonstration video<br/> <figure class="media"> <oembed url="https://youtu.be/Is0XPIWohWc"></oembed> </figure> </p> <p>Recommended slicer settings:</p> <p>-0.3mm (draft mode, for speed and strength)<br/> -4 perimeters walls or 3 (at least)<br/> -Infill 20-25% (not as important since perimeter walls do the job)<br/> -Printed fine without supports (will left barely noticable sloppy layer)<br/> -PLA "works", but not recommended for long term durability (PETG and more advanced filaments prefered)<br/> -VERTICAL orientation necessary for successful result (as shown on picture)</p> <p>Requires :</p> <ul> <li>2-3x flathead screws (for press)</li> <li>2x M3/M4/M5 flathead screws (for rope holder)</li> <li>2x M3/M4/M5 Nuts (for rope holder)</li> <li>Any rope/cord (non-stretchy).</li> </ul> <h3>Print instructions</h3><p>Recommended slicer settings:</p> <p>-0.3mm (draft mode, for speed and strength)<br/> -4 perimeters walls or 3 (at least)<br/> -Infill 20-25% (not as important since perimeter walls do the job)<br/> -Can be printed without supports<br/> -PLA not recommended for long term durability (but it works)<br/> -Vertical orientation as shown on picture for best quality.</p>