Handle with latch

thingiverse

This door latch and handle is designed specifically for a 4mm plexiglass sheet, requiring only a 22x15mm slot to be cut out along its edge. The handle simply slides into place once inserted. For added security, a small amount of glue can be applied to hold it firmly in position if necessary. To secure the lever, thread a piece of filament through the designated holes. Mounting the strike is effortless with double-sided tape or screws. Printing this design requires no support material. However, for a more refined bridge, note that when printing, the upper hole for the lever pin in the handle part does not pass through the first bridging layer above the slot. As a result, it may need to be opened up using a fitting metal pin. This is an integral component of my take on the 'IKEA Lack printer enclosure' concept.