Hand vacuum wall mount

prusaprinters

<p>We recently replaced an old hand held vacuum with a fancy new 'Lithium powered' Black &amp; Decker model (Model No. HHVJ315JD10). After unboxing it, I realized that the only way to store the thing was to lay it down. Our old unit had a charging cradle that mounted to the wall, so we had it mounted up out of the way in a closet.</p><p>The new vacuum didn't have a mount, and Black &amp; Decker doesn't make one for it either. I did notice that the underside of the vacuum had a slot that was angled upward. I measured it out and modeled up this mount. It attaches to the wall with two bugle head drywall screws. The vacuum is light enough that wall anchors are not required, but you may use them if so inclined.</p><h3>Print Settings</h3><p><strong>Rafts:</strong></p><p>No</p><p class="detail-setting supports"><strong>Supports: </strong><div><p>No</p></div><p><strong>Resolution:</strong></p><p>0.2mm</p><p class="detail-setting infill"><strong>Infill: </strong><div><p>40%</p></div><p><strong>Notes:</strong></p><p>print on its side</p></p></p>Category: Organization