Hand Support for Lancia Ypsilon 2003

thingiverse

I built this dashboard for my wife's used car because it lacked a mount at the co-pilot's seat. Installation is straightforward with the right screws, which I'll detail in the threaded mounting holes located near the dashboard itself. The holes measure 7mm at the bottom to secure the piece against the car frame and 12mm at the top for screw passage and head allocation. My installation was trouble-free, but you may want to increase the infill percentage above 60% to enhance part strength. This write-up is intended for anyone who might find it useful. Print Settings: Printer: P3STEEL Rafts: Yes Supports: Yes Resolution: 0.2 Infill: 70 Notes: I printed this in black ABS because car temperatures can get extremely high inside the vehicle. This part was printed on its side, and as you can see from the attached pics, the results are acceptable.