HAMPTON BAY FAN REMOTE WALL HOLDER/MOUNT

thingiverse

My Hampton Bay Mena 54 inch fan from Home Depot didn't come with a wall-mount for the fan remote, so I designed this. It has a flat back because I use 3M sticky stuff to mount it. https://www.amazon.com/gp/product/B000BL2REK/ You could easily drop this into Tinkercad if you wanted to make a screw hole in it. Orient vertically for printing. I print at .2mm layer height with 50% cubic infill in PLA+ with no supports. I print with a brim but it's probably not necessary if you get good adhesion. Took 3 hours and 17 minutes at these settings on my Creality Ender 3 and used 20 grams of filament. You could probably print at a finer layer height if you want smaller layer lines and don't mind a longer print time. Holds remote that is 18mm thick and 35mm wide by default, but you can scale it to fit your different needs, obviously.