Hammer 7

thingiverse

Hey guys, Here's my take on Jason Bodi's Build Hammer 7 Shotgun after a couple years of tweaking - one version I'm excited to share with you. The pump handle needs to be printed separately from the arm; simply use Gorilla glue to attach them. More than 30 have been made, and none have broken in the past three years. For the stock, a simple turn of hockey tape or electrical tape around your 13ci will keep it in place - I'm confident you'll figure it out! The lower can be held in place by an AR-15 grip. The ASA screw in the back and pump handle pin from the rear hold everything together; you don't need the front screw. Remember, this is a 3D print, so if you fall hard on the grip, it might break - that's just part of the deal! Good luck with your print, and be sure to give Jason Bodi a big thanks on Facebook for creating this build. I'm from Canada!