Halloween Pumpkin Fang

thingiverse

I'm Carving Venom's Fangs for Halloween. I wanted to bring out the best in my pumpkin, so I decided to add some of Venom's signature pointy teeth. They're super effective at putting any jack-o-lantern over the top. I searched everywhere but couldn't find a good match, so I made my own fangs instead. There are two types of fangs available - they look very similar but one slants slightly back more than the other. Both have a socket on the bottom where you can attach them to the post with a little super glue for a strong bond. To insert into a pumpkin (or gourd), hold the fang in front of you at your desired orientation, rotate it 90 degrees along its long axis, push the fang assembly into the gourd up to the base of the tooth, then rotate back 90 degrees. The locks in the post should hold the fang firmly in place. This design was made for printing large groups (I can get about ten at a time without any issues). This is my first experience with FreeCAD and also my first three-dimensional modeling in a long while, so I appreciate your feedback!