Halloween Desktop Pumpkin Catapult

prusaprinters

<p><strong>Bring pumpkin chuckin' inside with this super cute rubber band powered Halloween catapult.</strong>&nbsp;</p><p>The catapult prints flat without supports and is designed in layers for a multicolor effect through filament swaps. Notches and tabs keep your rubber band in place.</p><p>The catapult is decorated with spider webs, skulls and a friendly jack-o-lantern. The swing arm is a witch's broom. Due to decorations there is a Side A and Side B.</p><p>Use an ordinary office rubber band for power. When printed at 150% we launched candy corn pumpkins 20 feet (6 meters)!</p><p>The pumpkin is printed separately to allow for extra color swaps. A single color file is also included.</p><p>The entire catapult fits on an Prusa Mini or Ender 3 at 100% (and up to 200% on a Cr10S).</p><p><strong>Assembly Instructions</strong></p><p>All files print FLAT with no supports. Yes, the broom prints ok without supports (keep the tab pointing up as I've prepared it for you).</p><p>Assemble catapult by inserting crossbars &amp; swing arm into the holes in the frame. The larger bar goes on top, the swing arm goes in the middle (larger hole).&nbsp;</p><p>Add an ordinary rubber band to the top of the catapult – there's a notch to keep it in place – and behind the swing arm. Double the rubber band for extra power.</p><p>Add glue if you like, but the rubber band will hold everything in place.</p><p>*Tinkercad Skellies not included.</p>