Hall sensor Ender 5

thingiverse

This is the Z Hall endstop for Ender 5, or other. It's designed specifically for a 2020 profile and rotates the plug on a 90-degree angle.\r\nFor reference, see the included picture.\r\nTwo M3 holes are located inside the case to secure the board, but they are actually not necessary.\r\nAll components should be soldered from the traces side, except for the three-pin connector.\r\n\r\nIf the total thickness of the bed is approximately 6mm - no adjustments are required. \r\nYou will need five 2mm magnets and to create a M4 thread using a tap.\r\n\r\nPrinted with HIPS material.\r\nBe cautious, as only one side of the magnet activates the switch.\r\nDue to its long range of sensitivity (~5-6mm), some modifications are necessary in Marlin:\r\nConfiguration_adv.h\r\n#define Z_HOME_BUMP_MM 0\r\nIt will home once, or\r\n\r\n#define Z_HOME_BUMP_MM 6\r\nfor twice homing, as usual\r\n\r\n\r\nThis is an experimental project. It functions well, but has some issues.\r\nTherefore, I recommend installing an LJ12A3-4-Z/BX inductive sensor. https://www.thingiverse.com/thing:3725057