Half hanger

thingiverse

Foldable hanger with clips that could also be produced through 3D printing, but I happened to have some spare materials. Without clips, this item can hold up to ten ties. Feel free to share any improvements you might have in mind. Print Settings: Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: No Supports: Yes Notes: To achieve a smaller size, I printed the design scaled down to 50% of its original dimensions. This resulted in an overall diameter of about 10 inches or 25 cm. Nozzle setting: 0.6 mm I used standard settings recommended by Ultimaker for CURA 2.4.0 (or 2.3.x) on my Ultimaker 2+ printer. Post-Printing: Assembly Instructions: To assemble all the parts with the body, you will need a thin wire or a steel cord. First, make sure the cord fits through the holes of the body and the holder parts. If necessary, enlarge the holes slightly for easier assembly. Shape the cord into a half-circle shape, as shown in the picture, so it can easily pass through each hole of the body. Before assembling all the parts, try fitting the shaped cord through the holes first. This should go smoothly if you have formed the correct shape. Then, while pushing the cord, gradually assemble the parts to ensure everything fits properly and easily. In most cases, very little adjustment will be necessary for some parts to fit correctly.