Hakko T12 tips holder

thingiverse

This is a tips holder for Hakko T12 (and clones) tips. I designed it to be fixed securely with double-sided tape on top of the case created by "vtoryh" at Thingiverse, located here: http://www.thingiverse.com/thing:1220238. You can easily adjust the number of supported tips in the OpenSCAD source code by modifying the "BaseTipNum" parameter. When extracting the tips, be careful not to lift them too high as it's possible to break their base plastic cap, although this is not an easy task. Be aware that since the tips are grabbed over their label, they can be damaged by the holder fingers. Printer Settings: Printer: CTC Bizer Dual Rafts: Doesn't Matter Supports: No Resolution: 0.2mm Infill: 20% Post-Printing Process: After printing is complete, you might need to clean up the holes on the base...