Hakko T12 AT/ATX version front (STM32 and simple version)
thingiverse
Power source connected between minus 12 volts and plus 12 volts. We have 24 volts for fast heating. 3 diodes were replaced in the minus 12-volt line. They were rated for only one ampere of current. Replaced with 5-ampere diodes. A red LED-diode was added between minus 12 volts and 12 volts, using a 10-kilohm resistor. The STM version starts with some delay. What's all this AT modification? ATX mod requires the use of "power on" signal (the green wire connects to ground - the black wire). This is a very cheap and good solution with many options and mega-fast heating (about seven seconds). The PCB was bought from Taobao. Print Settings Printer: Hesine M-505, Bowden E3D V6 Rafts: No Supports: No Resolution: 0.2 millimeters Infill: Poor
With this file you will be able to print Hakko T12 AT/ATX version front (STM32 and simple version) with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Hakko T12 AT/ATX version front (STM32 and simple version).