Hagar the Horrible

thingiverse

Hagar, from the comic strip 'Hagar the Horrible', stands at an impressive 27cm tall when including his sword. Printing the pieces in suggested colors requires no painting whatsoever. In fact, supports are not needed for this model either. Despite his fierce appearance, Hagar is a gentle soul and a true pussycat at heart. So go ahead, print him out and enjoy the experience! Print Settings: Printer: FlashForge Creator X Rafts: Doesn't Matter Supports: No Resolution: .2mm Infill: 10% Notes: Printing without rafts is perfectly fine for all pieces, but based on individual experiences, the sword and smaller parts might require a brim or raft. Some users prefer printing small items with higher infill levels and two shells. For models with many curves and no flat tops, five top layers are recommended. Building the Model: Colors and Multiple Printed Pieces: White: horn_right, horn_left, face, shirt, boots Grey or Silver: helmet, sword, shield, shield_handle Black: eyes (2 copies), shield_rivet (6 copies), shield_center, helmet_rivet, bootstrap (2 copies) Red: beard Yellow or Gold: sword_guard Brown: tunic_top, tunic_bottom, belt, tunic_pin (2 pieces) Flesh or Peach: arm_right, arm_left, legs, nose Assembly Instructions: Assembling Hagar is straightforward, thanks to the diagram below. Special Note: Bootstrap Pieces are printed flat and require a simple loop made by gluing the ends together. This model was printed in ABS and turned out highly flexible. Ensure that the bootstrap slides over the top of the shoes before gluing them to the legs. Assemble the shield first, then attach the shield_handle piece to it. Once dry, insert the shield_handle into hand_left and glue it securely.