Hades - Eternal Spear

cults3d

This model is easy to print but difficult to assemble. I put it into 4 parts, spearhead, pummel, leaves and diamond. Spearhead and pummel are cut into 14 pieces and 6 pieces respectively to fit in my Ender 3 with platform size of 200mm x 200mm x 200mm. Uncut version of each part also included just in case you need it. All the pieces are easy to print with flat face that can lay on the printing bed easily. You can also print them in upward position which will reduce the "staircase" artifacts on the surface but will result in plenty of support needed and longer printing time. There is picture with pieces labelled to their file name attached in the preview section for you to refer in getting the pieces you want to print. Tunnel with 10mm diameter can be found on the pieces for bone installation and alignment purpose. You can print the "peg" file if you can't find anything that can assist you in this. Once print, glue pieces a and b together to form a part. Repeat the same for the other pairs and join them together afterwards. Small holes of 2mm in diameter can be found on the spearhead, diamond and leaves if your printer manage to print them well. To make the leaves and diamond to have a floating effect, you can bridge them with transparent acrylic rod. If you can't find 2mm rod, you can use drill those hole to a suitable size that can hold your material. I put the leaves in a set for easier printing and I would strongly suggest you use brim to print this part. To bridge the spearhead and the pummel, you can use 25mm rod or other suitable material. If can't find any, you can print the file "pole". It is a cylinder with 180mm in length. You can print multiple copies to achieve the length you want. For scale please use the same scale factor for all the pieces. Cheers and Happy Printing!