HackerBox JamBox Case

thingiverse

This is a case for the JamBox that was part of HackerBox #0028. To assemble, start by printing 8 buttons and one each of the other parts. Hold the lid upside down and insert the buttons into their respective holes. Next, carefully place the JamBox into the bottom part of the case, making sure it fits only one way. Secure that assembly together by pinching the board against the case using the breadboard section. Once secure, turn everything upside down and fit the lid over the assembly. Carefully guide the clips into place. Note: This is a new clip system I'm experimenting with, and so far, it's working exceptionally well. However, one potential drawback is that disassembling the case without breaking any clips can be quite challenging but not impossible.