Haas UMC-500 cable holder

prusaprinters

Both parts are designed to be pressed togetther, to keep the cable in place, and stopping it from rubbing on the frame.  Please refer to the picture of the 2 parts connected, to see how they should fit together, and they are designed to be printed sideways on the printbed, so no support is needed, this also makes it stronger, so it better can hold op to the vibrations from the Haas.  How to install:1: place part 1 on top of the frame.2: slide part 2 into the grove on part 1, so they both interlock, and clamp on the frame, this should be a press fit, if it slides in too easy, then you can simply just print part 2 slightly bigger.3: insert a zip/cable tie into the opening.4: place the cable on the round cutout of the part of part 1.5: tighten the zip/cable tie around the cable, to keep in place.