H8R suppressor

thingiverse

This is a functional suppressor for the air soft Umarex H8R revolver. To assemble, you need some low-density foam about 15 mm tall and a hot glue gun. Note: be careful with the hot glue to not melt the filament. Assembly Directions Step 1 Cut the foam into circles that fit the suppressor's internal diameter (about 36-37mm) enough to allow each disc to fit snugly in the body. Make three of these discs. Step 2 Cut a small X in the middle of each disc and use a pen or drill bit to widen the hole. Step 3 Put hot glue on the bottom side of the first disc and insert that disc into the bottom of the body. Step 4 Carefully try to get some hot glue inside the body around mid-length. Insert the next disc about halfway up the body where the glue will hold it. Step 5 Put hot glue around the inside edge at the end of the body and insert the last disc so it is flush or slightly inset from the top of the body. Step 6 Hot glue the cap onto the final foam disc securely.