H4N Mic Stand Remix with Knobs

thingiverse

Was really bummed out that I didn't have the knobs and screws needed to wrap up the project as showcased in the initial post, so I made some adjustments to the Mic Stand bracket to accommodate a 4MM-.7 x 25MM hex head screw from Home Depot, along with a matching nut. Then, I created a SCAD (sorry, can't recall who to credit) and produced knobs for the aforementioned screw, as well as for a 1/4" thread x 3/4" Hex head screw to fit the H4N. I felt that the mount piece in its original design was a bit too flimsy, and when attached to the Zoom, it would slightly warp. So, I beefed it up a notch, and you'll find that modification here as well. It works really smoothly now. I haven't printed the thicker part yet, but the other piece prints fine.