H-Rail Quick Mount with Sony SRS-XB12 mount.

thingiverse

Here is a H-Rail Mount System for Small Lightweight Items Requiring Only a 1" Ball Size. It Also Includes a 1" Ball Mount for the Sony SRS-XB12/XB10 Bluetooth Speaker. The H-Rail mount has been designed to clip onto and ratchet around the rail's 12 points. Once it has been zip-tied or cable-tied in the provided 8mm grooves, it cannot leave the rail. The Sony mount has been engineered so that some heat is applied via a heat gun or lighter to bend the "fingers" into creating tension and holding the speaker better. Both the Sony mount and the H-Rail mount utilize a 6.3mm x 30mm reinforcement rod inserted inside the ball shaft. If this diameter rod is not available, any cut-down bolt can be used. The rod must be glued in place using a 2-part epoxy. The M6 wing nut features an enclosed nut that is printed mid-print. When printing at a resolution of 0.2mm (recommended), you will need to pause the print at layer 86. To facilitate this, I provide a "Pause" post-script for S3D if needed. Place the M6 nut on the bed before inserting it to ensure it reaches optimal temperature and results in a better layer above the nut. If you prefer not to use the printed wing nut, any M6-sized wing nut will suffice. **Please note** When printing the Sony mount and H-Rail mount, please remove the supports from the shaft holes as they are not necessary. This will make removal and insertion of the rods much easier. The final model for the Sony mount features a window for the play buttons moved forward 2.5mm to better fit the speaker. The photos show the older, unedited model. Required hardware includes: * 2 x 6.3mm x 30mm rods (for Sony and H-Rail mount reinforcement) * 1 x M6 40mm Stainless Steel Hex bolt (for arms) * 1 x M6 Stainless Steel nut (for wing nut) If you download this, please give it a like!