Gyroid Infill Shelf Brackets

thingiverse

Set the top and bottom layers to 0 to reveal the infill pattern I used 8% infill, at 8% infill the part is reasonably strong but I wanted a nicely defined infill. 15-20% would be better for strength but would make the pattern less noticeable. I created this to use as gussets for an over-monitor shelf to fasten to my desk. They could be scaled up or down for a number of uses. There is a .3 countersunk standoff inside so that 1" screws can be used on 3/4 thick wood without screws protruding. CURA SETTINGS Print Quality - Standard Quality Layer height - .2mm Wall Thickness - .8 Wall Line Count - 5 Horizontal Expansion - 0 Top Thickness - .8 Top Layers - 0 Bottom Thickness - .5 Bottom Layers - 0 Infill Density - 7.5 Infill Pattern - Gyroid Print Temp - 200 Build Plate Temp - 60 Print Speed - 120mm/s Enable Retraction - Yes Z Hop When Retracted - Yes Generate Support - no Support Placement - Everywhere Support Overhang Angle - 45 Build Plate Adhesion Type - Skirt