GX470 Ride Height Switch Cover

thingiverse

This is a crude cover for the no longer used height adjustment switch. I needed a place to mount a switch and since I am no longer using the rear air suspension I used this spot. This cover was maybe 5 minutes in Tinkercad so it's not perfect. It needed a little trimming on the corners to get it to press fit in. Been using it for a few months and so far it's stayed put and looks fine. At some point, I'll probably spend a bit more time and make it fit a little better. But hey, went from idea to in my car in under an hour so that was good enough for me for now. Drilled the hole for the switch after the fact. Again, it's not a great fit, but worked for me by trimming the edge off two of the corners on the bottom for a press fit in a couple of minutes so figured I'd share. Printed in PETG Carbon fiber for whatever that's worth. The cracked wood was like that when I got the car.