Guitar SD-Card Holder

thingiverse

I designed a SD-card holder shaped like a Stratocaster that can hold up to 10 SD-cards. I created the model in Blender 2.82. The guitar case has a tricky design, and the hinges might break off easily when printed, so keep this in mind if you decide to print it. I also designed a stand for the guitar but didn't attempt to print it. It took approximately four and a half hours to print the guitar on an Artillery Sidewinder X1 at 0.2mm layer height using PLA material. The guitar case, however, required eleven hours to print on an Anycubic Predator at 0.16mm layer height also with PLA material.