Guitar Pickup Button Adapter V2

thingiverse

This is a follow-up to my initial design: https://www.thingiverse.com/thing:1087912 UPDATE: The small retainer kept getting misplaced or cracked. To resolve this issue, I redesigned it to eliminate the retainer and create a smaller, lighter version that snaps onto the pickup button. This adapter is specifically designed for guitar pickup buttons. Generally, because the 1/4-inch (6mm) plug for the guitar cable passes through the center, the outer diameter of the strap button is significantly larger than usual. This makes using a standard guitar strap a real challenge. You have two options: either enlarge the button hole in the strap end or use an adapter like this one, which is easy to print (approximately 6 minutes) and simple to use. To install it, simply slide the larger circle over the pickup button, then pull until the smaller diameter is seated inside the pickup button. I had to loosen my strings and manually guide the pickup back through the sound hole to adjust the inner nut. This was not a pleasant experience, especially with a 12-string guitar. (Using an old guitar string to guide it back into place and then out through the end hole on the lower bout can be helpful if needed.) It's still a good idea to use rubber strap locks with this setup for added security. Remember to thoroughly test your work before putting it to use. Weak parts can lead to a guitar ending up on the floor, which is entirely avoidable. It's your responsibility as the maker. I used eSun black PETG filament at 235°C and 50% cooling with 0.25mm layers and 20% fill on an Original Prusa i3 MK3 3D printer.