Guitar Hero / Clone Hero - Mechanical Conversion Kit

thingiverse

#####This is an attempt to open source as many as possible of the parts for the Guitar Hero / Rock Band controllers to turn them into mechanical models. If you have modelling requests or contributions that aren't filled yet (still plenty parts to go) don't hesitate to get in touch so we can keep it all collected, with proper attribution of course! #### Update October 13th #####Added: Guitar Hero Fret Rubber Grommets #####Coming: Xplorer frets. Whammy bar housing for select models. Wii-mote cover + backside. Battery covers ##Frets: Fits any Les Paul, World Tour, Kramer, Warriors of Rock and GH5 Guitars (PC/Wii/PS3/Xbox) 13.5mm fits in most models (with the fret switch holder) **Print-note:** Infill 5-20% and supports. Also verify print orientation for overlapping lines on the pushing side of the fret, orient as necessary. ###**These are not for original switches!** **Print-note:** Rotate to standing angle. Infill 3% (lines) 10 line brim at 0.1 for smallest weight and highest quality, add more infill if you think the buttons are too light. At the settings mentioned each fret weighs in at 1.93g after printing. ##GH Fret Rubber Grommets (eTPU 95A filament): Should fit almost any Guitar Hero Fret **Print-note:** 20mm/s speed, 0.1 layer height, 20mm/s retraction speed, 1.4mm retraction. No Z-Hop. ##Strumbar: Note: There are three strumbars, they fit Les Paul, WT/GH5 and Kramer/Xplorer. **Needs mechanical strum switch holder bracket for low profile mechanical switches** **Print-note:** Infill 100% and supports. ##Mechanical Fret Switch Holder: Should fit any Les Paul, Kramer, Xplorer, World Tour and GH5 Guitars Has been redesigned from ground to ensure compatibility with more guitars, in addition to taking less space and allowing for simple cable routing. **Print-note:** 0.2 - Infill 100% - Supports. ##Mechanical Strum Switch Holder: Should fit any Les Paul, World Tour, Xplorer, Kramer, GH5 Guitars **Print-note:** Infill 100%. ##Guitar Wall Hanger: Fits any guitar with a normally shaped neck (wouldn't try with the Logitech) **Print-note:** Infill 50+%. ##USB-C RJ11 Port Replacement for GH5/WT USB-C Breakout that fits: https://www.aliexpress.com/item/1005002795893679.html **Print-note:** Print with USB-C hole facing buildplate with supports (only touching buildplate)