Guitar Hanger

thingiverse

I had to lift my guitar off the floor and relocate it (following instructions from my wife). I used a modified design for a Crossbow Hanger, adapting it to fit my guitar's narrower dimensions. The plan is available online at http://www.thingiverse.com/thing:1586551. To print this hanger successfully, use the side that will face the wall. This eliminates the need for any supports during printing. Although simple in design, the hanger gets the job done effectively. Print Settings: Printer: I used my FlashForge Creator 1. Rafts: None were required. Supports: No supports were needed during printing. Resolution: A print resolution of .27mm was used. Infill: The infill percentage was set at 50%.