Guillotine

thingiverse

Made a quick remix because I broke one of the legs putting this together and didn't want to reprint the whole kit card. Also great if you want to make this multicolor. Building: I find it easiest to start with the two legs and the middle blade support. Snap the middle support into the slots and make sure it clicks all the way into the legs. Then slide the blade into the middle slot (the thinnest slot) of the legs on each side. When doing this you want the longest tip part of the blade to be going into the side of the middle support that is wider. This allows the blade to slide all the way down fully. After that, click the top support in the top slots of the legs. If the hole on this support does not allow the top of the blade to easily slide in, you need to flip it around. If it is still not lining up double-check that every support is fully clicked into the legs. After this just click the bottom support into the legs. Now you are ready to attach a rubber band to the blade and use the key to hold the blade in place at the top. Remove the key and watch the blade snap down Notes: Two versions of the bottom support because I was having a hard time getting the original to fit.