Guide durite frein arrière Honda CR ( Honda CR Brake hose )

thingiverse

Honda CR 125/250/500 Brake Hose Guide for the 1990 Models. This guide is specifically designed to assist with brake hose installation on the 1990 Honda CR 125, 250, and 500 models. The steps outlined below are tailored to ensure a safe and effective installation process. First, locate the existing brake hose and take note of its routing through the frame and fork. Carefully remove the old hose by unscrewing the banjo bolt at the caliper end and pulling it free from the master cylinder end. Next, inspect the area for any debris or dirt that may have accumulated during removal. Use a soft-bristled brush to gently sweep away any loose particles. Now, take the new brake hose and attach it to the caliper by screwing on the banjo bolt. Be sure to tighten securely but avoid over-tightening, as this can damage the threads. Move on to the master cylinder end, where you'll find a small clip holding the hose in place. Release this clip and slide the new hose onto the nipple. Finally, route the brake hose through the frame and fork, following the same path as the original hose. Make sure it's securely attached at both ends before giving it a gentle tug to ensure there are no kinks or twists. With these steps completed, your 1990 Honda CR 125/250/500 is now equipped with a new brake hose, ready for safe and enjoyable riding.