Guide Adapter for Harbor Freight 2.5HP Plunge Router

thingiverse

Changes V1: Decrease outer diameter from 69 to 68.8 Added chamfers Added ledges to withstand screws tightening Ledges are 0.6mm off print surface, support rafts included and are 0.4mm, so there should be a 0.2mm gap V2 Changes: Made ledges diameter smaller from 9.8 to 9 Raised ledge and top height by 1mm; adapter is almost flush with base plate, brass guide is recessed by 1mm V3 Changes (Experimental): Raised inner circle by 1mm so brass guide should be flush again Placed pocket in bottom for locking nut to be closer; this will require supports that touch platform; make sure those supports come out clean unless you like dremeling Came out fine for me V3.5 Changes (Experimental): Same as before, except included floating raft in center; still needs supports for the raft, not yet tested