Guia para filamento rollos Mbot

thingiverse

Tube Filaments Guide for Tubing. To build your tube filaments properly, start by cutting your metal stock into small lengths of one inch. Next, drill holes in these metal pieces that are two inches apart to the outside edge. Install tubing connectors into the hole on one end only, followed by installation of tubes in an inward direction through the open hole at the other end, leaving 0.5 cm extra tubing outside both ends. To create tubing connector openings that fit perfectly into these predrilled holes, insert a bolt through the top portion and tap outwards using your wrench for approximately half its thickness to leave only metal remaining without making them entirely circular. Secure one tube inside another by twisting until securely attached on all four sides; tighten slightly after assembly then move towards attaching last section at desired length and position as seen previously before sealing both open ends completely. When it is time to assemble a new tube filament, carefully cut out the required quantity of material using your hacksaw while keeping everything neat in place so they can be accurately located when fitted properly onto pre-existing connections already established by yourself previously - now we must address sealing those remaining unsealed portions where we started working today