gt2560 pin connector for Endstops

thingiverse

This is a Custom model I designed for the 2-pin connectors the GT2560 requires for the endstops. (Remember to print it 10% bigger for optimal results) Print Settings: Rafts: No Supports: No Resolution: 0.1 - 0.05 mm Notes: Print at 10mm/s speed, as size doesn't matter and full infill won't harm. Use the lowest temperature possible if you don't have a reliable cooling system. For better print quality, rotate it 90 degrees on the X-axis. How I Designed This Model: Why did I create this? I had an Arduino+RAMPS 1.4 board but unfortunately, it got burned out. When I couldn't find a replacement quickly enough, I purchased the GT2560 instead, only to realize that no RadioShack or electronics store carried the required pin connectors. Fortunately, the ATX and 3-pin fan connectors were available on Thingiverse, so at least those parts were covered. Unfortunately, finding suitable hot end connectors proved more challenging, which is why this model was born!