GT2 pulley for 6.35MM nema 23

thingiverse

Created with Customizer at http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Using the following settings: no_of_nuts - Value: 1 retainer - 1 retainer pulley_t_ht - Pulley thread height: 8 m3_dia - M3 thread diameter: 3.2 pulley_b_dia - Pulley bushing diameter: 20 nut_shaft_distance - Nut shaft distance from center of pulley: 1.2 additional_tooth_width - Additional tooth width: 0.2 teeth - Number of teeth on pulleys: 20 m3_nut_depth - Depth of M3 nuts: 2.7 retainer_ht - Retainer height above nut position: 2 idler - Idler count per set: 2 motor_shaft - Motor shaft diameter (5mm pitch): 6.35 m3_nut_flats - M3 nut flats in millimeters, spaced every mm around the thread. A space means there are no nuts in that position. - : 5.7 pulley_b_ht - Pulley bushing height: 8 nut_angle - Angle of each side on a standard M3 nut: 90 profile - Number of full width steps before changing tooth spacing to the value defined above: 5 idler_ht - Height added between each set of idlers. It can also add material and strength by providing more clearance between the shaft of an existing belt driven system to fit these gears. : 2 m3_nut_hex - M3 nut hex size, used when you wish to change your hex key in length. Hex is always 0:1, the rest just tells me which key goes inside. When it’s greater than .7 (default value for .5 key) that can indicate problems if you need one. : 1