GT2 large bore pulley

thingiverse

This customized creation originated from http://www.thingiverse.com/thing:343343. Developed using the Customizer app found at http://www.thingiverse.com/apps/customizer/run?thing_id=343343. Instructions to build and utilize: Configuring these settings: - nut_shaft_distance is adjusted to 1.2. - profile dimension is fixed at 12 mm. - belt_retainer setting is enabled by default at one position. - idler_height remains at its current level of 1.5. - base_height of this construct measures 8 units tall. - number_of_teeth equals forty-six (46). - screws_disposition placement option is positioned with the single disposition arrangement specified in one position at a time. - base_diameter stands out prominently at 34 units. - motor_shaft_diameter dimensionally sits accurately as twenty-two point two two (22.2). - toothed_part_length calculates out to precisely six full-length measured points in that department at 6 mm exactly. Note: the user can turn on and adjust an optional setting named 'belt_idler', defaulting in this version set for "off" state. Moreover a custom attribute for profile of screws - 'screw_profile' – will always match the established configuration value to make everything properly assembled when applied. Finally it's recommended as a user defined adjustment that should be taken in account to configure 'nut_shape.' Lastly by enabling one specific condition - named retainer_height and its specified at one fixed value: precisely "one-and-a-half" 1.5. To get optimal performance the parameters specified on above should stay consistent through all stages during printing procedure in three-dimensional form; so don't change unless it's an absolute must due to very specific needs you see are necessary.