GT2 Idler 0 tooth for 625zz bearing

thingiverse

Here are the rewritten text instructions using active voice at all times: Created with Customizer, a modified version of thing:16627 from http://www.thingiverse.com! Instructions to customize this design using the following settings: Set Pulley Base Height (pulley_b_ht) to 1.5 mm Specify M3 Nut Flats (m3_nut_flats) at 5.7 degrees Use an Idler bearing (idler = 1) Height of Idler (idler_ht) is set at 2.45 mm Depth of M3 nut (m3_nut_depth) is adjusted to 2.7 mm Diameter of Pulley Base (pulley_b_dia) is fixed at 10 mm Motor Shaft (motor_shaft) measures 16 mm Height of Retainer (retainer_ht) equals that of Idler at 2.45 mm Number of Teeth (teeth) set to 32 Using one Retainer (retainer = 1) Set the Number of Nuts (no_of_nuts) to zero. Pulley Thread Height (pulley_t_ht) is set to 6.1 mm. Distance between Nut Shafts (nut_shaft_distance) measures 1.2 mm M3 bolt diameter (m3_dia) is specified at 3.2 mm Select a profile size of 12 units for M3 nut depth. Set angle of M3 nut (nut_angle) to a precise 90 degrees. Tooth depth adjusted in addition equals -0.75 mm by Tooth width increases in addition up by 0.2 mm The hex diameter is fixed at one (m3_nut_hex).