GT2 Belt Clamp Ender 5 Y & X Carriage

thingiverse

Update No. 2, April 5, 2020: X-Axis Clamp Added The V2 is now without a spacer, while the V2.1 features a Spacer. The naming system remains the same: X_V2 has identical features to Y_V2 and so on. Status: V2 without spacer tested successfully; V2.1 not tested. Update No. 1, April 5, 2020: GT2_Clamp_Ender_5_Y_Carriage_Sling_Beltspacer_v2.1.stl is now available. This improved Version 2 features a Belt Spacer that presses the belt down by about 5mm into the 2020 Profile. The Spacer is 5mm wide, so there should be 0.5mm space left and right in the V-2020 Profile slot. Status: NOT TESTED. This design aims to create an easy-to-use fixation for Ender 5 belts. Three versions have been designed: One without a Sling, featuring a self-locking design; however, it was redesigned due to printing tolerances, which resulted in impractical teeth. -GT2_Clamp_Ender_5_Y_Carriage_without-Sling_v2.stl (not recommended) To improve the previous design, a Sling Version 1 was created. This version features a kind of spacer that is 6mm wide and pushes the Belt down to run more straight within the V-Slot. -GT2_Clamp_Ender_5_Y_Carriage_Sling_v1.stl (not recommended) However, due to issues with the V-Slot touching the carriage and tolerances at the carriage, a second version of the Sling Clamp was designed. This version features no spacer, which could cause friction at the 2020 profile. The end of the Sling is now open, allowing for longer belts during installation. ...this is: -GT2_Clamp_Ender_5_Y_Carriage_Sling_v2.stl -GT2_Clamp_Ender_5_X_Carriage_Sling_V2.stl A Version with a smaller spacer (5mm) has also been designed to reduce friction at the 2020 profile. -GT2_Clamp_Ender_5_Y_Carriage_Sling_Beltspacer_v2.1.stl -GT2_Clamp_Ender_5_X_Carriage_Sling_BeltSpacer_v2.1.stl Pictures are attached for installation and what to lose. It's easier to twist the Belt than expected. WARNING: Disconnect the Y-Stepper before adjustment and belt installation, as manual moves may cause a short circuit with fast stepper voltage values, damaging the board or stepper drivers. Simply pull the connector at the Y Stepper. My slicer settings for excellent results: Layer: 0.12 (cura Super Quality) Temp: 195°C Infill: 50% (cura Triangles) Support: NoSling = Yes Sling V1 = Yes Sling V2 = No Wall thickness: 1.2 (3 pieces) Upper Layers: 7 Lower Layers: 7 Speed: 80 Wallspeed: 40 First Layer Speed: 20 Support zigzag