gt2-8

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following options: Motor shaft diameter is set to 5.2 millimeters. Pulley top height is set to 12 millimeters. Belt pulley diameter is set at 20 millimeters. Distance from nut to shaft is exactly 1.2 millimeters. Nut angle is precisely 90 degrees. Additional tooth depth is zero millimeters. M3 nut depth is set to 2.7 millimeters. Retainer height above the motor shaft is 1.5 millimeters. Profile diameter is set at 6 millimeters. Idler option is disabled for this custom setup. Diameter of M3 nut is 3.2 millimeters. Number of M3 nut hex flats is five and a half millimeters. Belt pulley height above the motor shaft is set to 8 millimeters. One single M3 nut is used in this design. Retainer option is turned off for this custom setup. Idler height above the motor shaft is 1.5 millimeters. Number of teeth on the belt pulley is eight. Additional tooth width is set to zero point two millimeters.