GT2 60 Teeth

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following options: Pulley bolt diameter is set to twenty millimeters. Number of nuts required for assembly is one. Idler width is specified at ten units. Motor shaft diameter is fixed at five point two millimeters. M3 nut hex size is defined as one unit. Additional tooth width is added by half a millimeter. Retainer height is established at fifteen hundredths millimeters. Pulley bolt height is set to six units. Additional tooth depth is zeroed out. Idler height is specified at fifteen hundredths millimeters. Number of teeth on the gear is sixty. Retention system strength is ten units. Profile type is defined as two units. Distance from nut shaft is one point two millimeters. M3 nut depth is fixed at two and seven tenths millimeters. M3 bolt diameter is set to three point two millimeters. Nut flats size is five point seven units. Angle of nut orientation is ninety degrees. Pulley top height is established at eight units.