GT2 5mm Pitch / 60 Tooth / 16mm Tooth Height / 80mm Shaft

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions: Using the following options: Pulley thread height is set at sixteen millimeters. Nut shaft distance has been adjusted to point five millimeters. Pulley base height has been selected as eight millimeters. The nut angle is ninety degrees by default. An idler mechanism is enabled. Profile selection is fourteen millimeters. Number of teeth is sixty for optimal functionality. Additional tooth depth has not been increased, keeping it at zero millimeters. A retainer system has been implemented. M3 nut depth has been specified as two point seven millimeters. M3 nut hex specification stands at one unit of measurement. Height of the idler component is one millimeter high. Number of nuts included is just one for simplicity's sake. Retainer height also remains at a minimum of one millimeter. Pulley base diameter is set to twenty-five millimeters by default. No extra width has been added to each tooth for precision. M3 thread specification requires a three point two millimeter diameter screw. Motor shaft size has been chosen as eighty millimeters for maximum torque. M3 nut flat spacing is fixed at five point seven millimeters.