GT2 40T NISKI - lots of tooth profiles

thingiverse

Customized Version of Thingiverse http://www.thingiverse.com/thing:16627 Created With Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using The Following Options: m3_dia Is Set To 3.2 m3_nut_depth is Set to 2.7 Retainer Option is Activated at 2 Units motor_shaft Length is Measured as 5.2 mm retainer_ht Value is Precisely Set at 1.5 nut_shaft_distance is Accurately Positioned at 1.2 Profile Width Option is Set to Level Number of Teeth is Specified as Forty Pulley Body Diameter is Specifically Ordered for 30 Units m3_nut_flats Value has Been Corrected to 5.7 m3_nut_hex Property has Been Activated at One Unit Idler Height Measurement stands at 1.5 Additional Tooth Depth Option is Negatively Configured to Zero Pulley Body Height Value Has been Cleared of Previous Measurements to 0 units. Pulley Tension Height Has Been Corrected at Precisely Eight Units Nut Angle Parameter Set at Exactly Ninety Degrees Idler Switch Has Been Manually Disengaged At Position Zero Additional Tooth Width Specified at Exact Measurement Point, .2 mm.