GT2 2mm, 20 teeth, 7mm width Pulley

thingiverse

Temporary pulley assemblies, crafted for rapid prototyping of printers, will be soon replaced with sturdy aluminum counterparts to shield them from the heat generated by stepper motors which has a tendency to soften plastic components. This particular design is a customized iteration of the pulley system found at http://www.thingiverse.com/thing:343343, designed specifically to meet your precise needs. A customizer was employed in creating this pulley assembly. This application is available at http://www.thingiverse.com/apps/customizer/run?thing_id=343343. For assembling this component, please follow these instructions carefully: Choose from the options below to personalize the pulley assembly according to your specific requirements. * The diameter of the base should be set to 20. * To accommodate different needs, the profile is set at 12 by default. * You can decide the length of the toothed part. The default setting for this feature is 7 units. * The height of the base is adjustable and has a default setting of 8. * Determine the shape of the nut you require. Currently, it is set to option 1. * Adjust the diameter of the motor shaft according to your needs. By default, it stands at 5 units. * If required, you can add belt retainers or opt not to include them altogether, which has a current status of being included as an option 1 by default. * Decide the height of the idler; by default, it's set to 1.5 units. * For your specific requirements regarding retainer heights, set it at 1.5 units by default. * Position and count the screws that you require in the disposition part according to your need with an initial status of inclusion with disposition value of 1 * If additional precision is necessary for your component then set the tooth count to 20 which is the standard count or make the change based on requirements. * Adjust the screw profile to match your needs, and it has been set to a value of 4 by default. * For adjusting nut shaft distance, it stands at an initial default value of 1.2 units by requirement. Set your belt idler status to a "0" by preference as you have the feature available to toggle this switch off by default and do not desire to enable any engagement