Gryphon - Ehdrien remix

thingiverse

The stock replaces the grip scales and side mech covers to accommodate threaded rods. The replacement Mech covers require two additional pins to hold the "pusher support.stl" in place. Since I modified the exterior of the Mech covers, they no longer print with the exterior facing down. I removed the internal shelf that supported the pusher to save on support material. I used 10-24 threaded rod and 10-24 nuts to secure the shoulder stock. The "Cheekpad brace.stl" gets glued onto the inside of the cheekpad, stopping the lipo from falling out the front of the stock. It also adds a touch of elegance. I added foam padding in the stock to prevent my Lipo from rattling around in there. Some other parts that might need explanation include: The "Left side stripe.stl" glues onto the magwell on the left side of the blaster, creating a distinctive look. In my build, I wanted my orange Mech covers to resemble a stripe on the side of the blaster. This is purely cosmetic. I secured the "pistol grip padding.stl" onto the back of the pistol grip using double-sided tape. The butt pad is from 55samba's Talon Claw stock. A couple other parts of the stock were created by adapting parts of the same Talon Claw stock. Some other parts I used in this build include: I printed an Eotech shroud. https://www.thingiverse.com/thing:4184795 Rail covers (I had to do some sanding and shimming to get these to work) https://www.thingiverse.com/thing:3903386 Talon claw short angled fore-grip https://www.thingiverse.com/thing:3720920 Gryphon Carbine barrel https://www.thingiverse.com/thing:4139847 If you would like to support me in my 3D printed endeavors, you can purchase the files for my 3D printed folding sights on my Etsy store: https://www.etsy.com/ca/listing/781966141/3d-printable-folding-sight-set?ref=shop_home_active_1