Grr-Ripper Spacer

thingiverse

If you need to cut strips that are 1/4 inch or narrower on your table saw, this clever little spacer enables you to do so without damaging your Grr-Ripper push tool. Another option is a 1/8 inch leg accessory, but it's quite pricey. I've ordered a couple of the legs from Amazon and when they arrive, I'll conduct a comparison with this spacer. You will need a pair of #10 x 1 inch screws, and interestingly, I had to use #8 washers because my counter bore was too small. Fortunately, it still worked.