Ground Pod Classic

prusaprinters

<p>The Ground Pod Classic makes it easy to capture images while lying prone. A ball head can be used to provide stability. This camera pod was developed for my brother to be able to take nature photos supporting a large lens close to the ground, while laying prone.&nbsp;</p><p>It is made using “off the shelf” components, combined with a custom 3D printed structure to keep the camera steady. Flying discs are far more durable than any 3D printed part. Combining this with a 3D printed mount for a ball head, creates a durable structure.</p><p>&nbsp;</p><h4>Photography by Ash Ponders.</h4><p>&nbsp;</p><h4>Hardware:</h4><p>1/4” long 3/8”-16 UNC bolt (This is a photography standard)</p><p>A flying discs with an inner diameter of about 164mm, alternatively, this could be printed</p><p>Super glue (optional)</p><p>&nbsp;</p><h4>Files to print:</h4><p>If using a pre-existing flying disc:</p><ul><li>1x Ground Pod Classic Hub</li><li>6x Ground Pod Classic Centering Arm</li></ul><p>If using the all in one:</p><ul><li>1x Ground Pod Classic All-In-One</li></ul><p>&nbsp;</p><h4>Printing:</h4><p>Layer height: 0.28mm, anything lower than 0.2 is not suggested.</p><p>No supports</p><p>&nbsp;</p><h4>Prior to Assembly:</h4><ol><li>Clean out inbuilt supports in the center hole</li></ol><p>(If using a pre-existing flying disc):</p><p>&nbsp; &nbsp; 2. Drill a 15mm hole in the center of the bottom of the flying disc</p><p>&nbsp;</p><h4>Assembly: (If using All-In-One skip to step 5.)</h4><p>&nbsp;</p><ol><li>Slide a leg into the slot on the side of a hub.</li><li>Repeat 5 more times. This is easiest if done on alternative sides.&nbsp;</li><li>Grab prepared flying disc</li><li>Gently tap hub assembly into place.</li><li>Insert the 3/8”-16 UNC bolt into the hole in the bottom of the flying disc as far as it goes.</li><li>Screw ball head onto the exposed treads of the bolt.</li></ol><p>&nbsp;</p><p>Enjoy your Ground Pod!</p>