Groove Effector for Delta Printers

thingiverse

I got the idea to design this effector after seeing one published by Boofly at this link: http://www.thingiverse.com/thing:520580. In my version, you can disassemble the extruder without having to break up the printer as happened to me with the effector that came with my printer. One thing to keep in mind is that the Zmin limit switch needs to be triggered for floor leveling, which must be soldered onto pin NO because this version's trigger is reversed. When the extruder touches the plane, it opens the switch and snaps it shut. I added a side cover and support for LEDs. Please send me all your comments. Good 3D printing to everyone! Post-printing: As you can see from the photos, I used some pretty long screws because the springs on the market have high resistance compared to their size. With them, I was able to adjust the extruder with a margin of 0.02mm. I preferred to use self-locking nuts because normal ones unscrew due to printing vibrations. You can see from looking at the photo that the nuts holding the two halves of the collar on the moving effector plate are normal because these must be fully tightened.